Skip to main content

Oloid Verify - How to Re-pair Endpoint

This document provides step-by-step instructions to re-pair an endpoint in Oloid Verify app.

Introduction

This document provides instructions to re-pair an endpoint in the Oloid Verify app. Re-pairing reconnects the endpoint to its assigned application so it continues to work as expected.

Prerequisite

  • You must have Admin access for Tenant Admin Portal.

  • You must have the Endpoint ID of the endpoint.

Steps to Re-pair an endpoint

  1. Launch the Oloid Verify app on the device.

  2. Login to Admin mode with your Admin credentials. For more information, refer How to log in to the admin mode of Oloid Verify App as an Admin or Supervisor.

    The Settings tab is displayed.

    Note: On iPads running iOS versions below 17, the Settings tab appears at the bottom. On iPads running iOS 17 or later, the Settings tab appears at the top.

    The Enter Endpoint ID pop-up box is displayed.

  3. Enter the Endpoint ID

  4. Tap Re-pair.


    The endpoint is re-paired successfully.

    Pop-up is displayed asking Do you want to log out of Admin Mode to launch the application?

  5. Tap Yes to exit Admin mode and launch the application.
    ​Note: Tap No to stay in Admin mode.


    Keywords

    Oloid Verify re-pair endpoint | Oloid Verify endpoint troubleshooting | Oloid Verify reconfigure endpoint

Did this answer your question?