How to install M-Tag?

This guide describes how to install the M-Tag hardware

Updated over a week ago

Installation process of M-tag involves attaching the M-Tag on top of the existing badge reader.

Oloid M-Tag comprises the following:

  • M-Tag Reader Cover

  • M-Tag

M-Tag Reader Cover

Rear Side Reader Cover


To attach the M-Tag on top of the existing badge reader,

  1. Open the M-Tag Reader Cover. No screws are needed for Reader Cover.

2. Place the M-Tag inside the reader cover and close the back cover.

3. Unscrew the cover of the existing Badge Reader.

4. Remove the existing badge cover.

5. Place the M-tag Reader over the existing Badge Reader and press to fit it.

The installation is complete and M-Tag is ready to use.

Did this answer your question?