Steps to create and configure Device Lock application:
Log in to the Oloid Portal.
On the Applications page, click Create Application in the top right corner.
The Create New Application pop-up box is displayed.
On the pop-up box, do the following:
Enter Application Name and select Application Type as Passwordless.
Click Next.
The Select Passwordless Use Case page is displayed.
Select Device Lock.
Click Create.
The Passwordless application of type Device Lock is created and the configuration page is displayed.
Do the following:
Note: These are one-time settings and all the default settings are recommended.
Details tab: Modify Application Name, Add Description(Optional).
Authenticator tab: You may enable one or more credential option based on your requirement.
Face:
To use face as credential Enable Face.
The Advanced Settings page is displayed.
On the Advanced Settings page, configure Face Match Parameters, Face Capture Settings, Liveliness Check Parameters.
Note: The parameters are pre-configured. This is done by Oloid admin.
Badge ID: Select a Badge Type from the dropdown list. Enable Badge ID credential, and then enable Pin for multi-factor authentication.
NFC/ID: Enable NFC/ID credential, and then enable Pin for multi-factor authentication.
Connections tab: Add Connections to map a connection to the application and click Add.
Note: Click Save after each action to save your configuration.
The Device Lock application is configured and listed on the Application page.
