Skip to main content
How to configure CloudKey?
Updated over a week ago

To configure CloudKey follow the below steps:

  1. Log in to the Oloid Portal.

  2. On the homepage of the portal, click user profile icon on the bottom left corner of the menu panel.

    The user profile menu is displayed.

  3. Select Settings.

    The Tenant Settings page is displayed.

  4. Go to Advanced tab.

  5. Under Credentials section select CloudKey.

  6. On the Cloudkey Settings page, do the following:

    1. Turn on Enable CloudKey Proximity check to set GPS Refresh Frequency and CloudKey Distance.

      Note: Cloud key Proximity check if enabled will make only those CloudKey endpoints visible which are within the proximity range. If not enabled, all the endpoints will be visible.

    2. To set the GPS frequency, adjust the GPS Refresh Frequency.

    3. To adjust the distance setting, modify the CloudKey Distance.

      Note: Turn off the Enable CloudKey Proximity check to allow users to unlock doors without distance constraints.

    4. Click Save.

    The CloudKey is configured and is ready to be use.

Did this answer your question?