Introduction
This document explains how to perform the initial configuration of the Oloid DeviceLock app after installation. The setup includes granting required permissions to enable core functionality and ensure secure operation of the application.
Note: Screenshots in this document were captured on a Samsung Galaxy Tab A11 device.
Prerequisite
You must install the Oloid DeviceLock app. To install refer How to install Oloid DeviceLock App.
Steps to configure Oloid Device Lock Application
Tap Open to launch the app.
The Data & Usage Consent screen is displayed.
Tap Agree.
The grant Camera and Recording permissions pop-up box is displayed.
On the pop-up box, tap one of the following:
While using the app – The app can use the permission only when it is active.
Only this time – The app can use the permission once, temporarily.
Don’t allow – The app will not be allowed to use the permission.
The Oloid DeviceLock to send you notifications popup box is displayed.
Tap Allow.
The Appear on Top screen is displayed.
Turn on Oloid DeviceLock toggle to allow the app to appear above other apps > tap Back.
The Location access popup-box is displayed.
Select one of the following.
While using the app – The app can use the permission only when it is active.
Only this time – The app can use the permission once.
Don’t allow – The app will not be allowed to use the permission.
The Oloid DeviceLock is installed, and initial configuration is done successfully.
Keywords
| Oloid DeviceLock initial configuration | DeviceLock setup | Setup Device Lock application |