Skip to main content

Windows Login - How to enable Auto Launch Mode in Windows Login application

This document provides step-by-step instructions to enable Auto Launch mode in Windows Login application.

Introduction

This document provides step-by-step instructions for enabling Auto Launch Mode in the Windows Login application. When enabled, the Windows Login app automatically launches on the Windows pre-login screen, allowing users to access the configured Oloid authentication options without manually launching the application.

Prerequisites


Steps to enable Auto Launch Mode:

  1. Log in to the Tenant Admin Portal.

  2. On the Applications page, select the application paired in the Supervisor App (Windows Authenticator App).


    The application page is displayed.

  3. Go to Configure > Settings tab.

  4. Turn on Enable Auto Launch Mode toggle button to automatically launch the Windows Login app on the pre-login screen.

    1. Set Time-Out for Login screen. This duration will define the time the system will wait on login screen.

  5. Click Save.

The configuration is saved successfully. See, Sample screen for Auto Launch Mode

Note: Note: This note applies only to Windows Login Version 1. In the Windows Authenticator app, you must sync the configuration for the function to work. For more information, refer How to sync configuration in Supervisor App


Sample Screen for Auto Launch Mode


Video Tutorial


Keywords

| How to enable Auto Launch Mode | Auto Launch Mode in Windows Login | Enable Auto Launch| Auto Launch on Device |

Did this answer your question?