All Collections
Passwordless Authenticator
Credential Management
Factor Sequencing for Multi-factor authentication in Oloid Device Lock
Factor Sequencing for Multi-factor authentication in Oloid Device Lock
Updated over a week ago

Introduction

Multifactor authentication (MFA) is a process that requires users to provide additional forms of identification to sign-in to their Okta account. These additional identification methods include badge authentication and Pin verification.

Configuration

To enable MFA for the Oloid Device Lock app, perform the below steps in the Oloid Portal:

  1. Create "Application".

    Note: You must create an application of "Passwordless" type.

  2. Create "User".

  3. Add "Connection" to the "Application".

    Note: Add the same Connection to the Application in which the User is present.

  4. Assign "NFC/ID".

  5. Add "Pin".

    Note: By default, the Pin is set to 4 Digit Numeric Pin. You can configure the Pin length. For Pin configuration, see How to configure the Pin.

The Oloid DeviceLock app is now configured and ready for use.

For step-by-step instructions to create an application, read How to create an application.

For step-by-step instructions to create an user, read How to add an user.

For step-by-step instructions to add Connection to the Application, read How to Configure Application Type - Passwordless.

For step-by-step instructions to add face, read How to onboard face of a single user.

For step-by-step instructions to add pin, read How to add Pin as credential to users.

For step-by-step instructions to assign NFC / ID, read How to assign NFC/ID as credential to users.

Did this answer your question?